ProMaster Speaker System 8026 User Manual

0

Out of 0 Ratings

Owner's of the ProMaster Speaker System 8026 gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 4
 
When to change the battery
The indicator light above the off and on switch will flash when the microphone is turned on if
the battery is good. When the battery level reaches approximately one hour of remaining use,
the indicator light will glow and the battery should be replaced. A CR2 battery will normally last
for up to 800 hours depending on the frequency and pattern of use.
Caution
1. Use only a primary (non rechargeable) CR2 lithium battery. The battery supplied cannot
be recharged.
2. If you will not be using the microphone for an extended period of time, remove the battery
before storage.
3. If the battery leaks, be sure to thoroughly clean the battery compartment before installing
a new battery.
Connection
Slide the foot of the microphone into to the accessory shoe of your camcorder or DSLR (see
Figure 1). Turn the locking wheel to fix the microphone in place. Be sure that your camcorder
or DSLR is POWERED OFF. Insert the mini stereo plug of the microphone into the external
microphone input of your camcorder or DLSR. (See Figure 2)

   Find Your Products By Category